Javad Maxor, User Manual

Page: 53 / 142

www.javad.com Maxor User’s Manual 2-19
C O N F I G U R A T I O N
MinPad Configuration
decrements on every file rotation until it value becomes zero, then file
rotation automatically stops. The counter initializes with AFRM.
Note that a log file opens immediately after turning AFRM on. This startup
file is not considered a file rotation event; the AFRM counter will not
decrement.
Values are 0 to [231-1]. The default value is 0 (zero). Zero means that an
unlimited number of log files will be created.
Notice: The receiver's memory holds up to 512 files.
•
Files (remain) - specifies the number of files left for the receiver to create
in AFRM.
•
Values are 0 to [231-1]. The default value is zero.
•
Automatically remove old files - when no free memory is available to log
data, automatically removes the earliest log file. If this parameter is
enabled, your receiver will erase the file with the earliest file creation
time/date. AFRM must be enabled to use this FIFO (First-In, First-Out)
feature.
The default value is off (disabled).
FN Key Mode parameter
You use these two radio buttons to program how the receiver will react when
pressing the FN key.
•
LED blink mode switch - pressing FN will toggle between the MinPad's
normal/extended information modes and start/stop data recording of Static
survey.
–FN pressed less than 1 second: changes the information mode (Normal or
Extended Information (EI) Modes).
–FN pressed from 1 to 5 seconds: starts or stops recording (Static post-processing
mode).
•
Occupation mode switch - pressing FN (less than one second) will insert
into the corresponding log file a message indicating that the survey type
has been changed from static to kinematic, or vice versa. If the REC LED
blinks green, the current mode is dynamic, if it blinks orange, the current
mode is static. For more details, see Table 4-1 on page 4-4, and refer to the
MinPad User's Manual and PCView User's Manual .
Initial Data Collection Dynamic Mode parameter
These radio buttons specify the starting occupation type descriptor inserted at
the beginning of receiver files logged. You select Static or Kinematic to