Javad Maxor, User Manual

Page: 78 / 142

3-8 Maxor User’s Manual www.javad.com
3
S E T U P A N D S U R V E Y
Surveying with the Maxor
After the survey completes, data the receivers collect can be downloaded onto a
computer and processed using post-processing software (for example,
Ensemble).
The procedure that follows describes the steps the operator should take to
perform a Static Survey using MinPad.
1.
Connect your receiver and computer. See “Connecting the Maxor and a
Computer” on page 2-8 for this procedure.
2.
Open PCView, click Configuration->Receiver->MinPad and specify the
following parameters, then click Apply (Figure 3-5):
•
Recording Interval – 15 seconds
•
Elevation Mask Angle – 15 degrees
•
File Name Prefix – last 3 digits of receiver serial number
•
LED blink mode switch – enable to start and stop static data recording
using the FN key
Figure 3-5. Configuration->Receiver->MinPad
3.
Click the Advanced tab and then the Multipath tab, set the following
parameters, then click Apply (Figure 3-6):
•
Code Multipath Reduction – enable
•
Carrier Multipath Reduction – enable