Jasic EVO 2.0 EM-160C, Operator'S Manual

Page: 45 / 82

45
SPOOL GUN OPERATION
Before starting any welding activity ensure that you have suitable eye protection and
protective clothing. Also take the necessary steps to protect any persons within the welding
area.
Spool Gun Welding Mode
The Jasic EVO EM - 160 & EM - 200C machines can both be used with our
optional spool gun which is a Euro style spool gun that connects to the
EVO MIG machines via the Euro outlet connector.
Connect the spool gun Euro plug to the (MIG) euro socket. Connect the spool
gun 9 pin control plug to its matching 9 pin socket located on the front panel of
the machine.
Ensure the trailing lead is connected into the “+” socket on the front panel of
the machine and tighten clockwise.
Insert the cable plug for the work clamp into the “ - ” socket on the front panel of the welding machine
and tighten clockwise.
Connect the gas hose to the regulator/flowmeter located on the shield gas cylinder and connect the
other end to the machine.
Before starting any welding activity ensure that you have suitable eye protection and protective
clothing. Also take the necessary steps to protect any persons within the area.
After connecting the welding leads as detailed above you will need to switch the power
switch on the back panel to
“ ON ”, select MIG welding mode ‘ A ’ and spool gun mode ‘ B ’.
Set the welding voltage and other parameters via the machine control panel
When the remote control function is enabled, the "Wire Feed Speed" is adjusted by the
potentiometer on the spool torch handle.
Ensure you have adequate welding current according to the thickness of the work and
weld prep being carried out.
Fit a 1Kg reel of welding wire to the spool holder and feed the wire through the drive rolls ensuring the
fitted roller sizes matches your wire type and size, then continue to feed the wire through the contact tip
again ensuring you have the correct size tip fitted.
Open the gas valve of the cylinder, press the torch trigger and adjust the gas regulator to obtain the
desired flow rate.
Pressing the spool gun torch trigger will start the machine and welding can now be carried out.
Adjust the “ voltage ” control knob on the front panel of the machine to set the correct welding voltage
and adjust the “ wire feed speed ” control knob on the spool gun.
Please Note:
•
The spool gun option can only be used in standard MIG welding mode, all other functions work as
standard MIG torch. Spool gun part number is JE
- SP250 - 6.
•
MIG Synergic function is disabled when the control panel is set to spool gun.
If there is no wire feed potentiometer built into the spool torch and Spool gun is selected and
remote control function is enabled, then welding current will not be able to be adjusted.
Spool gun part number is JE - SP250 - 6