Jasic EVO 2.0 EM-160C, Operator'S Manual

Page: 18 / 82

18
INSTALLATION OF WIRED REMOTE CONTROL (STANDARD)
Wired hand - held remote - control connection
As standard the EVO MIG EM - 160 and EM - 200 machines are fitted with a 9 pin remote
control socket (1).
This allows for the matching 9 pin plug (2) of the hand held remote control or a
foot pedal to be connected directly to the machine to offer the user remote
operation control.
PLEASE NOTE:
Check that the machine supports a wired hand - held
or foot remote control before installation.
WIRELESS REMOTE CONTROL (OPTIONAL)
Wireless hand - held remote - control connection
An option with the EVO TIG range of machines is for the operator to be
able to wirelessly control the welding current. To enable this, you
will require to fit the optional remote interface module.
Installation of the wireless receiver module
1) Remove the plastic cap ‘ A ’ shown in the image right and fit the wireless
receiver module as shown.
2) Remove the screws of the left side cover of the machine.
3) Remove the buckle from inside the front panel of the machine and pull out
the plug.
4) Insert the wireless receiver module ‘ B ’ to the front panel, and then connect the
connection line of the receiver module to the CN5 socket on the main board.
PLEASE NOTE:
Please check that the machine supports wireless hand
held or foot remote controls before installation.
The above operation requires sufficient professional comprehensive knowledge of electrical
circuits and electrical safety. Make sure the input cable of the machine is disconnected from
the electricity supply and wait for 5 minutes before removing the machine covers.