Jasic EVO 2.0 EM-160C, Operator'S Manual

Page: 37 / 82

37
OPERATION - MIG
Torch trigger operation modes
2T operation mode
Press the torch trigger to initiate the welding arc, the arc is extinguished when you release the trigger.
4T operation mode
When the torch trigger is pressed to start the process, welding begins and continues to work even after
the torch trigger is released (current and voltage setting dials on the control panel will still adjust the
welding condition).
At this time, the digital meters will display the actual current and voltage respectively.
When torch trigger is pressed again, stopping the arc is effected (welding/crater current and crater
voltage parameters in the welding settings can adjust welding condition).
The welding process stops when the torch trigger is released and post flow gas time will start.
OFF
焊枪开关
送 气
输出端子间电压
送 丝
焊接电流
焊接中
慢送丝
滞后送气时间
防粘时间
空载电压
提前送气
收弧
ON ON
OFF
焊接电流
收弧电流
Torch trigger
Gas supply
Output voltage
Wire feeding
Welding current
Pre - flow time
Burn back No load voltage
Post gas
Creep feed time
Welding mode
Crater current
Arc stops
提前送气
空载电压
防粘时间
滞后送气时间
慢送丝
焊接中
焊接电流
送 丝
输出端子间电压
送 气
焊枪开关
ON
OFF
焊接过程中请将焊枪开关始终设为" ON"
Torch trigger
Gas supply
Output voltage
Wire feeding
Welding current
Pre - flow
Burnback
No load voltage
Post gas
Creep feed time
Welding mode