Jasic EVO 2.0 EM-160C, Operator'S Manual

Page: 22 / 82

22
CONTROL PANEL - FUNCTIONS
Welding mode selection area and switch
The welding mode selection zone (shown right) contains the welding mode selection switch
and corresponding indicators MIG, MMA and Lift TIG.
Pressing the green mode selection key will allow you to choose the required welding mode
and the corresponding indicator will be lit according to your selection.
If the indicator is on, it indicates that MIG mode has been selected.
If this indicator is on, it indicates that MMA mode has been selected.
If the indicator is on, it indicates that Lift TIG mode has been selected.
TIG torch trigger modes
Torch trigger function modes: 2T, 4T, repeat and spot. Press the ‘ mode ’ key to select the
required welding trigger mode and depending on your selected TIG torch trigger option the
corresponding LED indicator will illuminate, see page 37 for further details.
Base metal and gas selecting zone
This control allows you to select the base metal and welding gas mixture options which include:

Carbon steel with 80% Ar + 20% CO2

Steel flux cored with 80% Ar + 20% CO2

Carbon steel with 100% CO2

Steel flux cored with 100% CO2

Stainless Steel with 98% Ar + 2% CO2

Steel flux cored with 100% CO2

Aluminium Mg with 100% AR
Users can select the desired base metal and gas combination by pressing
the selecting keys
Pressing either of these buttons will rotate the selection choice to light
up the LED of the material/gas required to be used.
Note: This function is not applicable when MMA mode is selected.
MIG Wire diameter selecting zone
Welding wire diameter options include solid wire of:

Φ 0.6 mm

Φ 0.8 mm

Φ 1.0 mm

SP
The operator can select the desired wire diameter by pressing the selecting key and the
corresponding LED will then illuminate to indicate which diameter sized wire is selected.
Notes: - Wire selection function is not changeable during welding or when in MMA mode.
- SP option is not available on all models.