Jasic EVO 2.0 EM-160C, Operator'S Manual

Page: 35 / 82

35
OPERATION - MIG
Before starting any welding activity ensure that you have suitable eye protection and
protective clothing. Also take the necessary steps to protect any persons within the welding
area.
MIG/MAG Synergic Welding Mode
Synergic Welding Mode:
Synergic mode is where Welding Power (Voltage) and Wire Feed Speed are adjusted together, rather
than separately, via a single Control.
The EVO range of MIG welders have been pre - program with various welding parameters including;
MIG welding wire size, the material type and shielding gas being used.
With this information, the machine sets itself up with the ideal parameters for welding.
You can then for added convenience set additional features such as material thickness being welded.
In most cases, It ’ s wire feed speed within the machine ’ s Synergic Program then sets the welding power
output to match your application. So, increasing wire feed speed will increase the machines power
output to suit.
The initial machine setup is as standard MIG (see from page 30/31) for further details.
The control panel image left is an example of the EVO
machine being set up in synergic MIG mode and the
following few pages will explain the setup steps of
operation.
Following on from the standard MIG mode selecting
synergic is easily actioned by pressing the synergic mode
button so that the synergic indicator is lit
‘ M ’ (as shown
left).
You may also have noted that the top display has now
defaulted to amperage rather than wire feed speed
‘ N ’ (as shown left).
Synergic Welding Control:
When in synergic mode welding amperage control becomes the default adjustment setting (as shown
above, and the upper rotary encoder and push button which when pressed will scroll the operator
through amperage control, wire feed speed and material thickness.
Synergic mode allows the operator to rotate the control dial clockwise to increases not only the welding
current but also the background wire feed speed and material thickness settings and rotating the dial
anticlockwise will decrease the wire feed speed ultimately reducing welding current.
Arc Length control:
In synergic mode, you can increase or decrease arc length voltage by – 5 ~ +5 volts of the programmed
value. "0" is the mid point and when accessed will be shown in the lower display. Turning the lower
control dial anti
- clockwise to shorten the arc length and rotating clockwise to lengthen the arc length.
M
N