Jansen 499.007, Operating Instructions Manual

Page: 7 / 48

Edition 06/2015 Page 7
2 Safety regulations
Appropriate safety equipment must be worn when working
with the welding bench (protective gloves, welder's head
protection, safety shoes and clothes)
This welding bench must be placed so that the clearance to
an object, all or any other hindrance is at least 2.5 m to the
pivotal point of the device (pivotal point is marked with yel-
low-black position point!).
This safety clearance must always be observed to ensure
that there can be no collision between the supporting table,
which is rotated horizontally, and any object, wall or other
hindrance.
The footswitch must be located outside of the slewing range
of the welding bench. It must not be operated if anyone is on
the welding bench platform or within the slewing range of the
welting bench!
Do not clamp in any welding parts that protrude a long way
out from the welding bench) or only attach them with special
care (stop the rotary motion)
If the location of the welding bench is changed, even slightly,
then it must first be disconnected from the power supply!
Safety clearances to possible hindrances must be checked
once more before recommissioning the welding bench. Only
then is it permitted to correctly reconnect the power supply.
The operating instructions must be observed during recom-
missioning!
The welding bench must be placed on an even, antislip, vi-
bration-free surface.
The hinged feet must then be used to level the bench. The
ring screws must be disassembled after transport with the
crane.