Jansen 499.007, Operating Instructions Manual

Page: 18 / 48

Page 18 Edition 06/2015
4.3.4 O utside stop
The horizontal clamping elements must be removed when working with the outside
stops.
First, the adjustment spindles are set to the required dimension. The digital dimen-
sion indicators are adjusted to the outer stops, i.e. the dimension indicators match
the outer dimensions of the element. The outer dimension of the element can be
used. If the lug protrudes over the outer stop then when adjusting the dimension you
must take into consideration that 2x the width of the lug must be removed from the
adjusting dimension.
Always nullify the spindle play when adjusting the dimension, i.e. always move from
the inside to the outside with the support plates to the exact dimension; this nullifies
the spindle play.
Place the cut profiles onto the support plates and butt against the outer
stop (in case of pre-cut tolerances, the adjustment spindle must be re-
adjusted to the dimension of the profile). Swivel the vertical clamping
devices onto the correct clamping position, place a support on the mitre
and clamp the profile tightly onto the support plate with the vertical
clamping element. Make sure that the element is correctly aligned.
If necessary, you can clamp the profile onto the outside stop with a bar clamp. To do
this, place the bar clamp on the inside of the profile and the outside of the outside
stop and then clamp.
You can now start riveting and welding.
Outside stop version:
Vertical clamp
Support
Outside stop
Element
Support plate
For Jansiol Arte (499.354) and Janisol HI (499.423) sys-
temes are special stop plates available. Look at the welding
table accessoires at the end of the dossier.