Jansen 499.007, Operating Instructions Manual

Page: 11 / 48

Edition 06/2015 Page 11
3. Turn the main system switch at the control cabinet to the I position

The green control lamp lights up

ready for operation

The green control lamp does not light up

not ready for operation
Reason: The motor protection switch has triggered
Feed to the footswitch is not OK , e.g. defective cable,
footswitch not connected to plug connection
The rotary drive of the welding bench is ready for operation as soon as the green
control lamp lights up. The clamping plane of the welding bench can be horizontally
rotated clockwise or anticlockwise by a motor. It is operated by the double footswitch.
Pressing the footswitch moves the horizontal clamping plane; releasing the
footswitch interrupts the power supply and the bench stops rotating. The bench re-
verberates slightly when stopping!
Additional operating instructions are contained in Chapter 4.3.
3.3.2 S witching off
The welding bench must always be switched off at the end of work!
Turn the main system switch at the control cabinet to the O position

the green control lamp goes off
3.4 Disassembling the welding bench
1. Turn the longitudinal slides parallel to the foundation so that you can drive under
the foundation with the forklift.
2. Turn the main system switch at the control cabinet to the O position.
3. Disconnect the mains plug from the power supply and place the cable rolled onto
the platform.
4. Disconnect the control cable of the control cabinet from the welding bench.
5. For transport, fully close the cross slides with the adjustment spindle.
The welding bench can be moved using a forklift (2T bearing capacity).
The welding bench can also be moved with a crane; there are two M12 threaded
boreholes in the foundation for this. The supplied M12 ring screws are screwed in;
the bench may only be hooked on at the ring screws.
Use four-strand hook rope or transportation belts to hook on.
(min. bearing load of crane 2 tons)