Jansen 499.007, Operating Instructions Manual

Page: 6 / 48

Page 6 Edition 06/2015
1.3 Correct use

The welding table is used to aid in welding Jansen steel profiles into fin-
ished window and door frames.

It is a clamping device to rivet and weld Jansen steel profiles into complete
frames.

Motor-drive for easy adjustment of the welding position.

Footswitch/control cabinet positioned outside of the hazard zone

All other uses are deemed incorrect.
1.4 Incorrect usage
It is not permitted to use the rotary motion and force for other
reasons that changing the position of the workpiece (element).
It is forbidden to rotate the welding bench when persons or
hindrances are within the hazard zone or even on the welding
bench itself!
The welding bench must not be used when it is not installed
compliant to the regulations and with the minimum clearances
to hindrances (see Chapter 2 Safety regulations)
Any manipulation to the footswitch by wedging or equipping
with an object is forbidden.
If the welding bench is not placed according to the regula-
tions then we cannot accept any liability for subsequent
damages resulting therefrom.
Do not clamp in any welding parts that protrude a long way
out from the welding bench, or only attach them with special
care (stop the rotary motion)
Use for any purpose other than that intended is forbidden.
The manufacturer or supplier does not accept liability for any
damages resulting from incorrect use of the welding bench.
The user accepts sole responsibility in such cases.