43
UMG 509-PRO
www.janitza.com
8.5
Ethernet interface
The Ethernet interface is located on the bottom
of the device. When connecting, make sure to
provide a sufficient connection area to accommo-
date the bending radius and connector type of the
Ethernet cable.
This connection area should not be smaller than
50 mm.
ATTENTION
Material damage due to incorrect network
settings.
Incorrect network settings can cause faults
in the IT network!
Consult your network administrator for the cor-
rect network settings for your device.
ATTENTION
Material damage due to security vulnerabilities
in programs, IT networks and protocols.
Security vulnerabilities can lead to data misuse
and faults and even the standstill of your IT infra-
structure.
To protect your IT system, network, data com-
munications and measurement devices:
·
Inform your network administrator and/or IT
representative.
·
Always keep the meter firmware up to date
and protect the communication to the meter
with an external firewall. Close unused ports.
·
Take protective measures against viruses and
cyber attacks from the Internet, e.g. through
firewall solutions, security updates and virus
protection programs.
·
Eliminate security vulnerabilities and update
or renew existing protection for your IT infra-
structure.
INFORMATION
The device is set to dynamic IP address as-
signment at the factory
(DHCP mode)
. These
settings can be changed as described in „11.2.1
Ethernet (TCP/IP)“ or via the GridVis® software.
(See www.janitza.com)
INFORMATION
We recommend using at least CAT5 cable for
connection.
Meaning of the LEDs of the Ethernet interface:
LED
Function
Yellow Blinks during network activity.
Green
Is illuminated when there is a connection
(link).
Ethernet port
Patch cable
PC/switch
Fig. Rear view of UMG 509-PRO with patch cable
