3.8 Connection of Chlorine Generator Electronics to an AquaLink
®
Control System
Many Jandy AquaLink Pool/Spa Automation systems can control the function of the chlorine generator (to
varying degrees depending on the model). The chlorine generator user interface will display “JA” when
any of the buttons are pressed while the AquaLink is controlling it. Adjustment of the chlorine production
rate or Boost mode can be controlled from the menus of the AquaLink controller. Boost mode can also be
activated from the chlorine generator user interface while the AquaLink is online. Refer to the Operation
Manual included with the AquaLink Pool/Spa automation system for more information. The chlorine
generator’s user interface will display temperature, salinity, service codes, and LED indicators as normal.
NOTE
The AquaPure and PureLink
chlorine generator electronics will communicate with AquaLink RS using
firmware versions JJ or later.
3.8.1 Wiring AquaPure Control Center to an AquaLink
Power Center
In the AquaLink
power center enclosure, wire the AquaPure
Control Center input power
directly
to the
LOAD SIDE of the filter pump relay (see Figure 14).
Filter Pump Relay
Aux. 3 Relay
Load
2
Line
2
Load
1
Line
1
To AquaPure
(240 VAC)
To Breaker
Panel
To Filter Pump
240 VAC
AquaLink Power Center
Figure 14. Power Connection between AquaPure Control Center and AquaLink Power Center
The Jandy AquaLink
and AquaPure
use a four (4) wire connection to communicate. Any outdoor rated four
(4) conductor cable, minimum 22 AWG, can be used. Locate the appropriate screw terminals on the circuit
board according to Figure 15. Wire the AquaPure
from the red 4-pin terminal bar to the AquaLink
red
4-pin terminal bar (see Figure 15).
OPTIONAL
4 3 2 1
RED
BLK
YEL
GRN
Red, 4-Pin
Terminal Bar
Chlorine Generator
Power Interface
Board
AquaLink RS Power Center
NOTE
The screw terminals are removable to aid in
installation.
IMPORTANT
Attach the wires to the like-numbered screw
terminals on both the AquaPure and AquaLink.
Figure 15. Communication Connection between AquaPure Control Center and AquaLink Control System
Page 23
ENGLISH
Page 23
ENGLISH
Jandy
®
AquaPure
®
/PureLink™ Power Center and Cell Kit
|
Installation and Operation Manual
