GUI Features
TM/
TMC/RM/RMC-2030GE
- 34 -
7.1.1 (c) Programmable Shutter Speed
“Programmable” Shutter Speed is set by entering a number in the “Expo (lines)” text box. Program-
mable is available in Continuous or Trigger mode. The Expo setting is used instead of the Scan Area
selection.
Figure 35. To use Programmable shutter speed, select Programmable.
7.1.1 (d) Expo (lines)
The “Expo (lines”) selection of the Exposure Control frame determines how long the shutter remains
open, since a certain amount of time is allotted to expose each line. A minimum of one line of pixels
must be exposed. The maximum number of lines is 2048. Enter the number of lines desired either by
clicking on the arrows in the interface, or by inputting a number directly into the text box beside the
“Expo (lines)” box. The control is inactive unless “Shutter Speed” is set to “Programmable”.
7.1.2 Configuring Trigger Settings
Trigger mode uses a manual or sensor command to control the shutter. The Trigger mode offers sev-
eral settings not available in Continuous mode.
7.1.2 (a) Pulse Width Control Mode
Pulse Width Control (PWC) is controlled by the external trigger. An external trigger is used to gener-
ate one discharge signal (Vsub) right after the active edge of the trigger. The exposure starts when
the discharge signal is in the off state. The exposure is off following the trigger active off. Exposure
time is controlled by the pulse width of the external trigger.
Summary of Contents for RM-2030GE
