About the Guide
This quick start guide is for reference only. Minor
difference might be found in user interface.
All the design and software here are subject to
change without prior written notice.
All trademarks & registered trademarks mentioned
are the properties of their respective owners.
Please visit our website or contact your local
service engineer for more information.
If there is any uncertainty or controversy, please
refer to our final explanation.
-
-
-
-
-
Step 1
Use the guide to mark & drill holes for the drywall anchors.
Step 2
Attach the mounting plate by drilling the provided screws
into the anchors from step 1.
Step 3
Attach the camera to the magnetic mounting plate,
and adjust lens as needed.
Step 1
Step 3
Connect the camera to a power source.
Scan the QR code or search “IC Realtime” in the Google Play
or App Store to download and install DASH App.
Step 5
Step 4
With your mobile device connected to a 2.4 GHz band, add a
camera by following the steps depicted below.
Run the DASH App, and then register a new account if you
do not already have one.
Step 2
The camera LED indicator will flash green when it is fully booted on.
Note:
Note:
If camera fails to to add or the WiFi connection is
changed. Reset the camera and repeat step 5.
Repeat step 5 for adding multiple cameras.
Mounting Surface
Hole Guide
Drywall Anchors
Mounting Plate
Self-tapping Screw
Camera
Make sure the mounting surface can hold at least 1lb.
Using the Dash App
Camera Installation
