Jabiru Aircraft
Pty Ltd
Instruction & Maintenance Manual
Jabiru 2200 Aircraft Engine
Hydraulic Valve Lifter Models
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
REVISION
0
1
2
3
4
5
6 7
8
9
Dated : June 2010
Issued By: DPS
Page: 76 of 116
L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx
No.
Operation
Tools Required
23 Start and inspect for leaks
-
24 Test Fly
Note: First flight is a test flight so fly
conservatively
-
25 Remove Cowls and inspect for anything loose,
rubbing or leaking.
-
26 Check Head bolt tensions torqued to 20 ft. lb.
-
27 At25 hours inspect engine installation. Change
oil and filter. Cut filter open and inspect. Check
engine leak down
-
28 If oil consumption is stable fill with W100 (W80
in cold conditions and W120 in very hot
conditions). If it is still using oil remain on run
in oil or seek advice from Jabiru Aircraft or local
authorized representative
-
7.7
Prop Strike Inspection
After ground contact with the propeller, check the crankshaft and prop flange for run out
as shown below.
Figure 38 Dial Indicator Position for Crankshaft & Prop Flange Run Out
Remove one spark plug from each head.
