Jabiru 2200, Instruction And Maintenance Manual, Page: 35 / 116

Jabiru Aircraft
Pty Ltd
Instruction & Maintenance Manual
Jabiru 2200 Aircraft Engine
Hydraulic Valve Lifter Models
This document is controlled while it remains on the Jabiru server. Once this no longer applies the document becomes uncontrolled.
REVISION
0 1 2 3 4 5 6 7 8 9
Dated : June 2010
Issued By: DPS Page: 35 of 116
L:\files\Manuals_For_Products\Engine_Manuals\Transition\JEM2204-9_I&M_unsigned.docx
6.12 Engine Inspection Chart
Note: READ ALL INSPECTION RQUIREMENTS PARAGRAPHS PRIOR TO
USING THESE CHARTS.
Annual Inspection
Each 100 Hours
Each 50 Hours
PROPELLER
1 Spinner * *
2 Spinner Flange * *
3 Spinner screws * *
4 Propeller * *
5 Propeller bolts/nuts - Tension * *
6 Spinner / Prop Tracking * *
ENGINE & ENGINE COMPARTMENT
Check for oil, fuel exhaust & induction leaks, then
clean
entire engine & compartment before
inspection.

Check flywheel screw tensions to 24lb.ft
1
,
2
*

Carburetor air filter
–
Check & replace if required
* * *

Engine baffles and air ducts *

Cylinders *

Crankcase & front crankcase seal *

Fuel hoses, lines and fittings * *

Intake and exhaust systems *
1
Note: if any screws rotate they must be removed, cranckshaft and screw threads cleaned
then re-installed with fresh Loctite 620 (Use no more than the size of a match head). Do
not remove all flywheel screws at once or loss of valve timing may occur.
2
Up to engine S/No. 2732
– not required on engines with the “starfish” steel flywheel
adaptor plate