Ivoclar digital PrograMill Base, Operating Instructions Manual

Page: 18 / 144

Safety
18
2.8 Safety instructions for individual operating phases
2.8.1 Transport

Only transport the device according to the description in these Operating Instructions
(“Transportation and Assembly”, page 29).

In order to avoid corrosion on the device and subsequent damage to the device, transport
and store the device only within the permissible temperature range and ambient
conditions (“Ambient conditions”, page 137).

Observe the notes on transport safety (“Setting-up the unit”, page 34). Risk of damage to
the processing and changer arm.
2.8.2 Initial operation

Ensure that this machine is only operated by trained specialists.

If the device has been stored in a cold environment or at high humidity, maintain a drying
or temperature adjustment time of approx. 4 hours (without voltage) at room
temperature before initial operation.

Before connecting the device, check that the supply voltage and frequency are correct at
the point of installation (“Electrical data”, page 137).

Observe the notes on the location site (“Choosing the location site”, page 29) and the
ambient conditions (“Ambient conditions for operation”, page 137).
2.8.3 Operation

Keep unauthorized persons, such as patients, children and animals, away from the unit.

In all cases of doubt regarding the safety of the device, switch off the device and take
suitable measures to prevent further use.

Prior to connecting power or operation, check the device, the accessories and protective
equipment for any damage.

Do not use damaged, non-functioning equipment or accessories; instead notify your
authorized service partner.

In order to ensure the product safety and warranty services, the device must be exclusively
operated with the original accessories from Ivoclar Vivadent. The user bears the risk when
using non-approved accessories.

Ivoclar Vivadent recommends using approved materials only to ensure process reliability.

Never bypass the safety equipment of the machine or set it out of operation (“Safety
instructions for potential hazard areas”, page 16).

Only operate the device when the milling chamber is closed and the loading aid and the
tank are in place.

To avoid damaging the unit and reducing the performance, follow the cleaning
instructions and cycles (“Cleaning by the user”, page 19 and “Cleaning and Maintenance
Work for the User”, page 125).

Only operate the device unsupervised if the operating conditions for unsupervised
operation described below are fulfilled.