Isgus Perfect 2020, Operating And Installation Manual

Page: 37 / 52

Programming 31
Signal Times for Signal Circuit
External signal devices, e.g. a horn for the organization of breaks or the plant
illumination can be switched on and off at defined times by the programming of
signal circuit.
Contrary to the check of individuals the signal circuit works person-independent, that
means the release of the signal completely takes place according to defined time
intervals.
The settings for signal time and duration for the signal circuit can be determined
separately for each weekday, same as in the menu "Ribbon color change".
Up to 16 signal times can be programmed per weekday,
If no times are entered for one weekday, e.g. on Saturday or Sunday there will be no
signal in the corresponding day.
Programming proceeding see section "Column change timing".
The signal duration will be selected in field D1 and is in seconds.
Change or delete signal times
All time values programmed can be changed or deleted at any time.
1. Call up Programming routine
→
key " R ".
2. Select menu "Signal times for signal circuit"
→
key " S ".
3. Select weekday with values to be changed
→
key " R ".
4. Select value to be changed
→
advance with " E ".
5. Change signal duration and/or signal time
→
key " R ".
To change further values on the same weekday repeat steps 4 and 5.
6. Quit entry for this weekday
→
key " S ".
To change any values on other weekdays repeat steps 3 to 6.
7. Quit menu "Signal times for signal circuit"
→
key " S ".
8. Quit programming routine
→
advance to the end of the programming panel
with " S ".
If you want to delete single values of a weekday, proceed as described above. To
delete the time value displayed, select "--" in the field D1 with the key "
R ". Confirm
the deletion command with " E ". Now the next time value programmed is displayed.
Now the menu can be left as described or new time values can be entered.