SERVICE MANUAL
© ISA, s.r.o. 2014-2015. All rights reserved.
We reserve the right to change the specification without prior notification.
Always check for new version of this document@
Service manual V1.08 | Nov-2015 | LM0002-EN
Page 34 of 97
10/0/10
LVLØ AUX2 Control (Send 1/0)
control pulse
edge 1/0
1 bit
W
1.001
Actuator to control "AUX2" output. Toggle current output status
when pulse edge telegram (0/1) will be received on this input.
Status feedback will be send when output changes state.
10/0/11
LVLØ AUX2 Status Feedback (1=On, 0=Off)
display of
status
1 bit
R
1.001
Status feedback of "AUX2" output.
NOTE:
Details are documented in “KNX bus communication” section 6.
For examples of KNX communication see section 6.4.
3.8
Lights
3.8.1
Overview
Lighting in the pool is used to create a pleasant atmosphere. Pool lights make it possible to use the pool
round the clock, at the same time as it provides added safety. Light output can be controlled by timer,
remotely from mobile application, by KNX or via integrated air switches or pushbutton connected to
“SWITCH AUX1” and/or “SWITCH AUX2” outputs (read section 3.7.4 for connection details). These outputs
can be freely assigned via LVLØ mobile application.
3.8.2
Electrical connection
LVLØ „LIGHT” output has direct AC 230V output. When using underwater lights, a
transformer which converts to safe electric energy 12V/24V, needs to be connected
to “LIGHT” output. Output can be used also without transformer with any ohmic
load (ex. Safe outdoor lightning, etc.).
;
see connector position details
in section 2.2.2.
This output is powered by built-in circuit breaker with lightbulb sign (picture) on
LVLØ device.
L – Phase output (L2)
N - Neutral
3.8.3
Configuration
Lights setup has to be performed via LVLØ mobile application in Service section; select AUX, Lights and
Cover.
Lights: <installed/not installed> defines if lights are installed in the pool. If “not installed” will be selected
the “Lights” button on Home screen will be disabled (grayed out).
Lights autostop time: <value> value in minutes. Defines delay after the light is automatically switched off
when AUX autostop mode is set to “automatic”. To disable this feature, set “AUX autostop mode” to
“manual”.
Lights button : <AUX1, AUX2, none> select function to trigger with air switch or pushbutton input. (See
section 3.7.4 for connection details).
AUX1 sequencer : <enabled, disabled> if enabled, air switch connected to “Switch AUX1” or pushbutton
connected to a terminal “Switch AUX1” will be able to resolve multiple click. With this feature it is
possible to control AUX1, AUX2 and lights with only one button. Press the button three times (3 clicks) to
toggle the light output.
Lights timer: Custom timer is used to define on and off times according to needs. With
button, you can
add a new entry. There is a possibility to define as many entries per day as needed. For deleting an entry,
