4
Maintenance and adjustment
68
Fig. 29:
Fig. 30
4. Place the hydraulic control levers in the
fully ‘DOWN’ position.
5. Remove, clean and refit the oil strainer.
6. Refit the drain plugs. Then refill the
system through the transmission oil
filler to the required level, with an ap-
proved oil (Fig. 28).
7. After allowing time for the oil to set-
tle, check the level of the oil, then, if
necessary, add further oil and refit the
filler plug.
Hydraulic pump (Steering and
linkage pump) oil strainer
(Figs. 31 and 32)
Change hydraulic pump oil strainer
every 1000 hours.
1. Drain the oil by removing the two drain
plugs as described on previous page.
2. Remove the three bolts (1 Fig. 31) and
washers securing the cover plate (2 Fig.
31).
3. Pull out the strainer (Fig. 32).
4. Thoroughly clean the strainer in paraf-
fin (Kerosene).
5. Using a new gasket, refit the cover plate
(2 Fig. 31), with the three bolts (1 Fig.
31) and washers.
Fig. 31:
2
1
Fig. 32:
Summary of Contents for ITM 950
