4
Maintenance and adjustment
69
6. Refit the two drain plugs.
7. Refill the transmission with an ap-
proved oil.
IMPORTANT
If any defect observed on the filter, re-
fer to nearest local distributer to change
the filter. Any small defect in oil filter,
can damage hydraulic system.
WARNING
Notify your ITMCO. Dealer if any leak-
age from the system occurs, for investi-
gation and rectification.
CAUTION
Check the fluid level only when it is
cool. Never run the engine unless there
is sufficient fluid in the reservoir. DO
NOT overtighten the plug.
1. Clean the outside of the steering pump
and removing all dirt.
2. Remove the filler/level plug located on
the hydraulic reservoir.
3. The oil level must be between min and
max of oil gauge.
NOTE
At the first Dealer Service (50 hours)
the steering pump filter and oil must be
changed by your ITMCO dealer.
WHEELS
Due to size and load on tractor wheels,
bear following points in mind when chang-
ing wheels:
- Before changing wheels, set the trac-
tor on hard, flat surface.
- Engage parking brake and prevent the
tractor from moving with safety wedg-
es.
- Remove key to prevent unauthorized
operation.
- When removing rear wheels, prevent
movement of front axle with safety
wedges or vice versa.
TRACTOR LIFT POINTS (Fig. 33)
Figure shows recommended lift points
for lifting tractor with a hoist.
A
: Lift of rear part of the tractor.
B
: Lift in point of front connection plate,
e.g. for lifting front part of the tractor.
WARNING
Lifting on axles is possible, but only
if you use a suitable base, which fits
sleeve housing. Otherwise, the tractor
can slip and cause serious injury!
Fig. 33:
A
B
Summary of Contents for ITM 950
