69
Edge Port
Ports may be configured as edge ports if they are connected directly to a
terminal device. These edge ports transfer directly from the blocked state
to the forwarding state without delay. As soon as the bridge detects a
BPDU coming to an edge port, the port becomes a non-edge port. By
default, all ports are edge ports.
P2P Port
A P2P port is also capable of rapid transition. Under RSTP, all ports
operating in full-duplex mode are considered to be P2P ports. By default,
port identifies a link automatically.
Instance ID
Configure port parameters in different instances.
Priority
By default, the port priority is set to 128.
Default Path Cost
Enable/disable port default path cost. You can specify a custom port path
cost between 1 and 200,000,000 if you disable the default port path cost.
When enabled, port path cost can be configured automatically and 802.1at
is supported.
Port Path Cost
The default path cost is 200,000,000. Only the default path cost is
disabled, can path cost be configurable.
Click
Config
on the Port Setup page
to configure STP settings on a batch of ports concurrently.
Port Statistics
Click
Device Management > STP > Port Statistics
to display STP port statistic info as below:
Summary of Contents for G3224P
Page 1: ......
