Chapter 4: Installing the Software
5536 PRI RAS Communications Controller Users Guide
49
–
For North America and Japan, select
µ
Law
(
Mu
Law
).
3.
Click
OK
.
If you have not yet configured the board’s ISDN port
properties, do so now, as described in
. Otherwise, continue to the next topic.
Completing the WAN Setup
When WAN card and port properties are configured as needed,
do the following to complete the WAN setup:
1.
Click
OK
in the WAN Adapters Setup dialog box.
The setup software finds firmware for the board. It
updates the registry and dynamically installs the drivers.
2.
When the following message informs you that the driver
is running, click
OK
.
Figure 4-10. Successful Setup Message
Next, set up RAS support properties for the driver.
Summary of Contents for ENTIA 5536 DM PRI
