Appendix B: Using the SynWatch Utility
5536 PRI RAS Communications Controller Users Guide
143
•
To start watch activity on an unwatched port or channel,
left- or right-click the checkbox beside the port or
channel.
•
To change the watch mode of a watched port or channel
without disrupting its watch state, right-click the
checkbox beside the port or channel.
When you select the port or channel on which to start or
change watch activity, a menu of watch modes appears. The
modes available depend on whether you select a D channel, B
channel, or port. If you select a port, B channel watch modes
are displayed, and the watch mode for the D channel defaults
to the LAP-D mode.
The following illustration shows the menu of watch modes for
a D channel:
Figure B-2. ISDN D Channel Watch Modes
Summary of Contents for ENTIA 5536 DM PRI
