Intermec Sabre 1555, Programmer'S Reference Manual

Page: 74 / 178

Sabre 1555 RFID & Bar Code Reader Programmer’s Reference Manual
4-34
Table 4-23 shows the submodule power-on/power-off function command.
RFID Function
RFID function commands configure the RFID portion of the Sabre 1555 parameters.
Table 4-24 lists the RFID function commands.
Table 4-23 Submodule Power-on/Power-off Function
Function Name
Submodule Power-on/Power-off <TYPE> <CMD>: \0A\0F + Prms
Description
This function requests power-on/power-off of a product’s submodule n if applicable (the
product is considered the submodule(s) controller).
This function must be sent to the controller module before using an IMC function if the
submodule requires activation.
When the submodule is powered up by the power-on command, the submodule is
initialized.
Parameters
Peripheral ID number, 1 byte [1]:
1 = RFID submodule
Mode [0 - 1]; 1 byte: 0 = deactivate the submodule; 1 = activate the submodule
Responses
IEC (IMC not activated)
ACC (command accepted and started)
NAC (command not recognized)
Note: If the product is powered by battery and a low-battery status is detected, the
product will send a PEV (product event) frame:
PEV frame: <PEV><Event number>, with event number = battery discharged (0x10)
Table 4-24 RFID Function Commands
Function Name
RF_Auto_Run <TYPE> <CMD>: \0A\10 + Prms
Description
This function launches the auto function(s) with parameters that are already present in
the product NVM parameters zone (see “RFID Auto Configuration Commands” on page
4-46).
The auto function(s) can be single or multifunction, e.g., identify, read, write, filter, or a
combination of these depending on the current operating mode (see “RFID Auto
Configuration Commands” on page 4-46).
Parameters
Mode [0 -1]: 0 = Read until time-out; 1 = Stop after one success or time-out
Time-out [1 - 30]
e.g., Mode 1, 10 s: \0A\10 \01\00\0A