Intermec Sabre 1555, Programmer'S Reference Manual

Page: 120 / 178

Sabre 1555 RFID & Bar Code Reader Programmer’s Reference Manual
4-80
Command Name
Reset Factory Defaults <TYPE> <CMD>: \0D\46\42
Description
Reset all parameters to their default settings.
Parameters
None
Responses
ACC (command accepted)
NAC (command not recognized)
Command Name
Product Hardware Reset <TYPE> <CMD>: \0D\4C\41
Description
This command restarts the product. Simulates cycling power. Product uses
configuration parameters stored in NVM. If in temporary configuration, settings are set
from those in NVM.
Parameters
None
Responses
ACC (command accepted)
NAC (command not recognized)
Command Name
Get Version Info <TYPE> <CMD>: \0D\46\43
Description
Software version
Parameters
None
Responses
ACC (command accepted)
NAC (command not recognized)
Command Name
Display Data String Mode <TYPE> <CMD>: \0D\46\4E
Description
Displays ASCII equivalents of data string and checksum values on a terminal screen
when you read configuration bar codes without implementing configuration bar code
settings. Remains active until the product is switched off or a PRC (\3F) is issued.
Parameters
None
Responses
ACC (command accepted)
NAC (command not recognized)
Command Name
Configuration Enable <TYPE> <CMD>: \0D\46\50
Description
Configuration possible all the time (default mode)
Parameters
None
Responses
ACC (command accepted)
NAC (command not recognized)
Table 4-38 Configuration Utility Commands (continued)