Intermec Sabre 1555, Programmer'S Reference Manual

Page: 87 / 178

Interactive Programming Mode
4-47
4
Command Name
Define RFID Auto Read Parameters <TYPE> <CMD>: \0D\4C\58 + Prms
Description
Defines the auto read parameters in the tags.
Parameters
Read field [0 - 3], 1 byte, hexadecimal
Start address [0 - 127], see Appendix C, base 64
Read size [1 - 32], 2 bytes, see Appendix C, base 64.
Note: Sum of start address and read size must not exceed 128
Responses
ACC (command accepted)
NAC (command not recognized, or parameters invalid)
Command Name
RFID Operating Mode Selection <TYPE> <CMD>: \0D\4D\40 + Prms
Description
Defines the current operating mode. AutoRun activates RFID operating mode.
Parameters
Set bits to activate fields:
0x01 = Tag Identify *default
0x05 = Tag Read
0x09 = Tag Write
0x0D = Tag Read Write
0x11 = Tag Filter
0x15 = Tag Filter Read
0x19 = Tag Filter Write
0x1D = Tag Filter Read Write.
Responses
ACC (command accepted)
NAC (command not recognized)
Command Name
Define RFID Auto Run Response <TYPE> <CMD>: \0D\4D\42 + Prms
Description
Defines whether the RFID Auto Run Response will contain complete or partial success
status.
Example: For an RFID Read operation of more than one field, when complete success
is activated, the BFR success frame is sent only if all fields selected are read correctly.
With partial success, the BFR partial success frame is sent, but the bit status must be
checked for each field read.
Default is complete success.
Parameters
[0 - 1]; 0: partial success; 1: complete success
Responses
ACC (command accepted)
NAC (command not recognized)
Table 4-33 RFID Auto Configuration Commands (continued)