Intermec Sabre 1555 RFID, Service Manual

Page: 45 / 65

Replacing Parts in the 1555
2-31
2
3. Install the piezo wiring plug in its connector on the handle PCB.
Piezo
connector
4. Place the RF board assembly in the lower shell. Make sure the flex cables are routed
correctly for the 1555 version.
Note: Be careful not to put any strain on the piezo wiring.
2.4 GHz
10-pin flex cable to
this side
915 MHz
All flex cables
to this side
5. Insert the 12-pin flex cable into the connector on the digital board. The contacts
must face away from the board. Be sure the cable is seated correctly and latch the
connector.
6. Insert the 8-pin flex cable into the connector on the back of the scan engine. The
contacts must face the digital board. Be sure the cable is seated correctly and latch
the connector.