Intermec Sabre 1555 RFID, Service Manual

Page: 24 / 65

Sabre 1555 RFID and Bar Code Reader Service Manual
2-10
Replacing the Exit Window
You need the following part to replace the exit window:
•
Exit window (P/N S620-OPT-001)
You need this tool:
•
Torque driver with a Torx bit
To replace the exit window
1. Remove the FCC label from the bottom of the case.
2. Remove the six Torx screws from the bottom of the case.
3. Carefully pull the front end of the upper case assembly from the lower case. Do not
separate the shells completely. Hold the RF board assembly in place in the lower
shell.
4. Remove the exit window from the upper case assembly.