24
InterServe 8400, InterServe 650/660, and StudioZ RAX Systems
The following shows the I/O panel on the back of the InterServe 8400, InterServe 650/660,
and StudioZ RAX systems.
PCI Slot 8
(Secondary
PCI Slot 4
(Primary)
PCI Slot 5
(Secondary)
To install the controller:
1. Ensure the system is powered off.
2. Remove the top cover from the system.
3. Remove the screw and blanking plate from an available PCI slot.
4. Install the MegaRAID controller. Press firmly and evenly over the PCI connector to
ensure the board seats completely into the slot.
5. Secure the board with the screw removed from the blanking plate.
6. If using the Channel 2 connector, see “InterServe 8400 Channel 2 Expansion” for
instructions to install and route the Channel 2 access cable.
NOTE
Channel 2 expansion is not available for StudioZ RAX systems.
7. Replace the top cover.
8. Install the disk array cabinet as described in “Installing the Cabinet into a Rack.”
