interco Ergoline Aktiv, Operating Manuallines

Page: 36 / 52

36
HEAD POSITIONING
To adjust the angle of the arm rest
proceed as follows:

Turn the fixing lever anticlockwise to
open the fixture (Photo
2 )�

The arm rest angle now can be adjusted�

Change the square pipe to the desired
position and turn the black fixing lever
clockwise to fix the square pipe�

The position of the arm rest will now
stay the same�

Repeat the same procedure on the other side�
5. Head positioning
The components for positioning the head are connected to the hard outer shell
with universal brackets� Any adjustment involves changing the insertion depth
of the square tube�
To do so, proceed as follows:

Turn the black knurled knob counterclockwise until the square tube slides
easily�

Slide the square tube into the desired position�

Then turn the black knurled knob clockwise to resecure the square tube in
place�

Repeat this procedure on the other side�
5 . 1 Head rest bracket, angled
The angled head rest bracket can be used to adjust the head rest at two levels,
height and depth�
To adjust the height, proceed as follows:

The universal bracket for the head rest bracket is located on the back side
of the hard outer shell� To adjust it, proceed as described under section
5 �
“Head positioning”�
To adjust the depth, proceed as follows:

Turn the wing screw counterclockwise to release the clamping device on
the top cross bar�

Slide the head rest bracket tube into the desired position in the cross bar�
2