interco Ergoline Aktiv, Operating Manuallines

Page: 33 / 52

ERGOLINE STANDARD EQUIPMENT
33
E
ng
lis
h

To open the buckle, press on the moving part� This will release the strap
and you can then pull it out� Please make sure to hold the patient in place
in the seat shell when performing this step�
3 . 3 . 3 Lap belt with press buckle
Preparation:
Place the patient in the seat shell�

Lay the lap belt over the patient’s lap with the inserter�

Press the inserter into the buckle while simultaneously pressing with one
hand against the patient’s pelvis�

Then pull on the free end of the strap until the lap belt has reached its final
position� You can verify this by checking to ensure that the belt is positioned
properly and pressure is evenly distributed along the patient’s pelvis�

To open the buckle, press hard on the red button in the middle of the
buckle� Please make sure to hold the patient in place in the seat shell when
performing this step�
Note: It is usually only necessary to adjust the belt once at the beginning� This
adjustment will be maintained even after you open the buckle� However, you must
check to ensure proper adjustment with each use�
3 . 3 . 4 Lap belt with deflection roller
Preparation: Place the patient in the seat shell�

Lay the part of the lap belt with the deflection roller over the patient’s lap�

Then pull on the other end of the belt using the deflection roller�

Then pull on the free end of the belt until the lap belt has reached its final
position� You can verify this by checking to ensure that the belt is positioned
properly and pressure is evenly distributed along the patient’s pelvis�

Secure it into position by connecting the free end of the belt with the hook
and loop fastener provided for this purpose�

To open the lap belt, release the hook and loop fastener�
Note: The belt must be adjusted with each use� Always check to ensure that the
belt is positioned properly each time you use it�
3 . 3 . 5 Pelvic harness
Preparation:
Before placing the patient in the seat shell, always check to ensure
that the pelvic harness is sitting flat against the seating surface with no folds�
Then place the patient in the seat shell as described in section
3 � 2 � (Using the
seat shell)�