34
ARM POSITIONING
Then, proceed as follows:
The pelvic harness is divided into two sections at the end toward the pa-
tient’s knees� The harness is equipped with one belt with a push-in buckle
for each leg�
Lay one of the belts from one side to the other over the patient’s thigh
and use one hand to press the press-in buckle inserter into the press-in
buckle� This receptacle is located at the corresponding edge of the seat
shell (right or left side, depending on which leg you are restraining)�
Repeat this procedure on the other side�
Check to ensure that the pelvic harness has been positioned properly� The
belt straps should support the patient’s pelvis without being too tight� The
harness should not have any folds or the like (risk of pressure areas!)
4. Arm positioning
The components for positioning the arms are connected to the hard outer shell
with universal brackets� Any adjustment involves changing the insertion depth
of the square tube�
To do so, proceed as follows:
Turn the black knurled knob counterclockwise until the square tube slides
easily�
Slide the square tube into the desired position�
Then turn the black knurled knob clockwise to resecure the square tube in
place�
Repeat this procedure on the other side�
4
.
1
Arm rests, height-adjustable (standard arm upholstery)
The height-adjustable arm rests are equipped with a standard cushion and se-
cured to the seat shell with universal brackets� Please read section
4
(Arm po-
sitioning) to learn about the steps required to adjust the arm rest height�
4
.
2
Arm rests, incrementally height- and angle-adjustable (standard arm upholstery)
The height- and angle-adjustable arm rests are equipped with a standard cush-
ion and secured to the seat shell with universal brackets� Please read section
4
(Arm positioning) to learn about the steps required to adjust the arm rest height�
Summary of Contents for Ergoline Aktiv
Page 48: ...48 SERVICE PLAN Notes...
Page 51: ......
