5-8 HP PCL Cursor Position Commands
PUSH/POP CONTROL).
ESC &f#S
Decimal:
027 038 102 # 083
Hex:
1B 26 66 # 53
#: 0 = push (store cursor position)
1 = pop (recall cursor position)
Use the push/pop command to store or recall the cursor position. Using the value 0 pushes
the cursor position onto the first in last out (FILO) stack while keeping the current cursor
position. Using the value 1 pops the cursor off the stack, restoring it as the current cursor
position.
You can push up to 20 positions. Any more than 20 are ignored. If you pop more positions
than you pushed, the command is ignored. If you reset the printer, the current cursor posi-
tion is placed on the top of the stack and all other pushed are lost.
If a position is outside of the addressable print area, the cursor is positioned at the edge of
the addressable print area.
*
"This information is subject to change without notice. This information is provided "as is" without either express or
implied warranty. IntelliTech International, Inc. disclaims any and all warranties with regard to this information.
IntelliTech shall not be liable in any event for any special, indirect or consequential damages or any damages whatsoever
resulting from loss of data, profits or use, for any reason or in any action, arising out of or in connection with the use or
performance of this information. "
Summary of Contents for Intellibar M412
Page 115: ...9 2 HP PCL Graphics Commands Figure 9 1 Star Shaped Raster Image...
Page 122: ...HP PCL Graphics Commands 9 9 Figure 9 4 Example of Raster Graphic Image Data...
Page 126: ...HP PCL Graphics Commands 9 13 Figure 9 6 Shading Levels...
Page 127: ...9 14 HP PCL Graphics Commands Figure 9 7 Fill Patterns...