IntelliTech Intellibar M412, Reference Manual, Page: 134 / 187

HP PCL Graphics Commands 9-21
The horizontal HPGL/2 plot size determines the horizontal scaling factor used to fit the
drawing into the PCL Picture Frame. For example, if the horizontal HPGL/2 plot size is
specified as 12 inches and the PCL Picture Frame width is 4 inches, the horizontal scaling
factor would be 3:1; the horizontal component of the image would be reduced to one-third
its original size to fit into the PCL Picture Frame.
A parameter value of zero or a reset, page length, paper size, or orientation command
defaults theHPGL/2 plot size to the width of the currently selected picture frame. This
results in no scaling.
HPGL/2 Plot Vertical Size
ESC*C#L
Decimal: 027 042 #..# 076
Hex: 1B 2A 63 #..# 4C
# = vertical size in inches
Default = width of the currently selected picture frame
Range = 0 tp 32767 (valid to 4 decimal places)
This command specifies the vertical size of the HPGL/2 drawing being imported.
The vertical HPGL/2 plot size determines the vertical scaling factor used to fit the drawing
into the PCL Picture Frame. For example, if the vertical HPGL/2 plot size is specified as 7
inches and the PCL Picture Frame height is 14 inches, the vertical scaling factor would be
1:2; the vertical component of the image would be enlarged to twice its original size to fit
into the PCL Picture Frame.
A parameter value of zero or a reset, page length, paper size, or orientation command
defaults theHPGL/2 plot size to the height of the currently selected picture frame. This
results in no scaling.
Set Picture Frame Anchor Point
ESC*c0T
Decimal: 027 042 099 048 084
Hex: 1B 2A 63 30 54
Default = 0
Range = 0
This command sets the location of the PCL Picture Frame anchor point to the PCL cursor
position.
The position of the picture frame anchor point defines the location of the upper left corner
of the PCL Picture Frame. The “upper left” refers to the corner for which X and Y
coordinates are minimized when the print direction is 0.