2-4 IntelliBar M Series Extensions to HP PCL Commands
If no Variable Form Length command is received, or the form length is set to 0, or a reset
(ESC E) command is received, the logical paper length and the paper movement are
determined by the value measured by the control panel’s “Automatic” or “Fixed” or
“Operator Panel” parameters. (The self-test is printed under these conditions.)
In PCL, Line Feeds off the bottom of the logical page cause a form feed, but vertical cursor
positioning commands off the bottom of the logical page position the cursor to the logical
page limit without printing the page.
Disabling Variable Form Length
ESC!f0Z
Decimal:
027 033 102 048 090
Hex:
1B 21 66 30 5A
This command disables the Variable Form feature.
Print Speed
ESC !p###S
Decimal:
027 033 112 ### 83
Hex:
1B 21 70 ## 53
where ### is a number (mm) that represents increasing print speeds (see Table 2-1).
This command controls the IntelliBar M Series printing speed. For example, ESC !p15S
sets the printing speed to 15 mm/sec (0.6 in/sec).
Table 2-1 IntelliBar M Series Print Speed Command Codes
### Value
Print Speed
15
15 mm/sec (0.6 in/sec)
20
20 mm/sec (0.8 in/sec)
30
30 mm/sec (1.2 in/sec)
40
40 mm/sec (1.6 in/sec)
60
60 mm/sec (2.4 in/sec)
80
80 mm/sec (3.1 in/sec)
100
100 mm/sec (3.9 in/sec)
120
120 mm/sec (4.7 in/sec)
150
150 mm/sec (5.9 in/sec)
200
200 mm/sec (7.9 in/sec)
250
250 mm/sec (9.8 in/sec)
300
300 mm/sec (11.8 in/sec)
Summary of Contents for Intellibar M412
Page 115: ...9 2 HP PCL Graphics Commands Figure 9 1 Star Shaped Raster Image...
Page 122: ...HP PCL Graphics Commands 9 9 Figure 9 4 Example of Raster Graphic Image Data...
Page 126: ...HP PCL Graphics Commands 9 13 Figure 9 6 Shading Levels...
Page 127: ...9 14 HP PCL Graphics Commands Figure 9 7 Fill Patterns...
