26
SBCEFCSW/SBFCM: HMM and Troubleshooting Guide
switch
Initiates an editing session in which to change switch configuration settings. Each parameter is
displayed, one line at a time and prompts you for a value. For each parameter, type a new value
or press the Enter key to accept the current value shown in brackets. Type
q
to cancel the
configuration.
MSEnable
Management Server enable on this port
NoClose
Do not close unless another device arbitrates
I/O Stream Guard
Enables or disables the suppression of RSCN
messages
IVIEnable
Not applicable
CheckAlps
Close before sending frames to new target
Table 8. Set Config switch parameters
Parameter
Description
AdminState
Switch administrative state: online, offline, or diagnostics.
Broadcast Enable
Enables (True) or disables (False) forwarding if broadcasting
frames.
InbandEnabled
Enables (True) or disables (False) the ability to manage the
switch over an ISL.
DefaultDomainID
Default domain ID setting.
DomainIDLock
Prevents (True) or allows (False) dynamic reassignment of
the domain ID.
SymbolicName
Descriptive name
R_T_TOV
Receiver Transmitter Timeout Value. Specifies the number
of milliseconds a port is to wait to receive a response from
another port. The default is 100.
R_A_TOV
Resource Allocation Timeout Value. The number of
milliseconds the switch waits to allow two ports to allocate
enough resources to establish a link. The default is 10000.
E_D_TOV
Error Detect Timeout Value. The number of milliseconds a
port is to wait for errors to clear. The default is 2000 msec.
FS_TOV
Fabric Stability Timeout Value. The default is 5000 msec.
DS_TOV
Distributed Services Timeout Value (Management Server,
Name Server). The default is 5000 msec.
PrincipalPriority
The priority used in the FC-SW-2 principal switch selection
algorithm. 1 is high, 255 is low.
ConfigDescription
The name for the configuration. The default is undefined.
Table 7. Set Config port parameters (continued)
Parameter
Description
