TwinLock
Assembly Instructions
12
Version 1.12
E)
System Setup
The system starts immediately after being connected to a power supply unit.
The user is then guided through the installation process. During this process,
the remaining locks are logged on.
(description see Chapter 2.7)
F)
Lock function check
After the installation process has been completed, it must be checked if the
locks unlock and lock correctly (description see manual).
TwinLock 7220:
The system/master code has been set to 1-2-3-4-5-6-7-8 by the manufacturer
TwinLock eCode/WTU/compact:
The mastercode has been set 1-2-3-4-5-6 by the manufacturer
The system/manager code has been set 111111 by the manufacturer
.
G)
Programming of the alarm control TwinAlarm
TwinAlarm activation
Configure the TwinAlarm input levels (description see manual).
TwinLock 7220:
The system/master code has been set to 1-2-3-4-5-6-7-8 by the manufacturer.
TwinLock WTU:
The Mastercode has been set to 1-2-3-4-5-6 by the manufacturer.
The system/managfer code has been set to 111111 by the manufacturer
.
H)
Other Programming Functions
In an unlocked state (all locks open), all programming functions may be
performed (descriptions see manual).
As all timer programs use them as a basis, the correct settings of date, time
and weekday are important.
When programming the code, you must make sure that the new
unlocking code is repeatedly being checked while the safe is open!
Do not use personal data when programming unlocking codes!
For security reasons, switch the system code or the master code of the
individual codes immediately after Installation.
