TwinLock
Assembly Instructions
Version 1.12
15
Cable routing to the keypad through the safe door
Direct both cables through the breakthrough in the safe door.
Plug the 4-pin plugs into the intended jacks of the circuit board on the back of the
keypad, according to Fig. 2.
Screwing the keypad to the safe door
The keypad case must be mounted to the outside of the safe door with 2 countersunk
steel screws M4, to ensure a permanent firm hold of the keypad case. To avoid
damaging the keypad case, the mounting screws may only be tightening using a
maximum torque of 1 Nm.
