‑27‑
2
Installation
Read through the safety instructions in Chapter "Fundamental Safety Instructions". Failure
to comply may result in serious consequences.
●
Observe the installation direction described in this chapter. Failure to comply may
result in equipment fault or damage.
●
Do not install or operate damaged or defective equipment. Failure to comply will
result in personal injury.
●
Do not install the equipment in environments exposed to water splashes or
corrosive gases. Failure to comply will result in equipment fault.
●
Do not install the equipment near inflammable gases or combustible objects.
Failure to comply will result in a fire or electric shock.
●
Install the equipment inside a fire‑proof cabinet that provides electrical
protection. Failure to comply may result in a fire.
●
Ensure the specified clearance is reserved among the servo drive, the interior
surface of the control cabinet, and other machines. Failure to comply will result in
a fire or equipment fault.
●
Do not put heavy objects on the equipment. Failure to comply may result in
personal injury or equipment damage.
●
Do not impose large impact on the equipment. Failure to comply may result in
equipment damage.
●
Do not block the air inlet/outlet of the equipment or allow unwanted objects to
fall into the equipment. Failure to comply may result in a fire or equipment fault.
2.1
Installing the Servo Drive
2.1.1 Unpacking Inspection
Check the following items upon unpacking.
Items
Description
Check whether the
delivered product is
consistent with your
order.
Check whether the servo drive model and specifications
comply with your order.
See the dimensions of the packing box in
. The deliverables include the product, cushion, carton box,
and screw bag, as shown in
Check whether the
product is intact.
Check whether the product delivered is in good condition. If
there is any part missing or damaged, contact Inovance or your
supplier immediately.
Summary of Contents for SV660P Series
