‑
64
‑
Note
●
[1] The range of the in24 V power supply is 20 V to 28 V, with maximum
operating current being 200 mA.
●
[2] DI8 and DI9 are high‑speed DIs that must be used according to their functions
assigned.
●
[3] Use the shielded twisted pairs for pulse terminals, with both ends of the shield
connected to PE. Connect GND and signal GND of the host controller properly.
●
[4] The DO power supply (voltage range: 5 V to 24 V) needs to be prepared by
users. The DO terminals support a maximum voltage of 30 VDC and a maximum
current of 50 mA.
●
[5] Use the shielded twisted pair cable as the encoder frequency‑division cable,
with both ends of the shield connected to PE. Connect GND and signal GND of the
host controller properly.
Summary of Contents for SV660P Series
