‑123‑
To reduce noise interference, use shielded twisted pairs to connect the 5V GND of the host
controller to the GND of the servo drive.
The maximum permissible voltage and current capacity of the optocoupler output
circuit inside the servo drive are as follows:
●
Maximum voltage: 30 VDC
●
Maximum current: DC 50 mA
3.8.5 Wiring of the Brake
The brake is used to prevent the motor shaft from moving and keep the motor and
the motion part in locked positions when the servo drive is in the non‑operating
status.
Figure 3‑35 Application of the brake
Summary of Contents for SV660P Series
