p16
Ver. 3.003 (24/4/03)
CONCEPT IQ. PLUS Programmer’s Manual.
Adding or Changing a User
1. Logon.
Enter your PIN code;
...
2. Select the first User number to be added or changed.
Press
,
,
,
. Where
is the User number (User 02 to User 47).
The <A1> Lamp will flash to indicate the system is ready for the PIN Code or Wireless
Remote Key entry.
If a PIN code is already programmed for this User, the corresponding number of Zone
Lamps (4 or 6) will be flashing.
3. Enrol the User’s Wireless Remote Key. (If required)
Press a button on the Remote Key within 30 seconds of selecting the User number.
Three short beeps will sound to confirm that the Remote Key has been enrolled and
assigned to the selected User.
If the Remote Key is already assigned to another User, or is not recognised by the system,
one long beep will sound to indicate a problem.
4. Enrol the User’s Card. (If required)
Present the card at the attached reader head and observe the tones.
High tones indicate acceptance, low tone indicate rejection of the card.
5. Enter the new PIN Code (may not be required if Wireless or Card used).
A Zone Lamp (1 to 4, OR 1 to 6) will Fast flash to indicate which digit of the PIN code is to
be entered.
If the Zone Lamp flashes Slowly, it indicates that a PIN Code is already programmed for
this User. If you enter a new PIN number it will replace the existing PIN number.
As each digit is entered, 3 very short beeps will sound to indicate that the entry is ac-
cepted, and the next Zone Lamp will now Fast flash for the next digit to be entered.
Enter the new PIN number
... (4 or 6 digits), then press
When complete:
-Three short beeps will sound to confirm the new PIN number has been programmed.
-If the PIN is rejected, one long beep will sound to indicate a problem.
6. Assign or Change the User Area or Areas.
(Only required if you have a Multi-Area System)
The <A2> Lamp will flash to indicate the system is ready for the Area assignment entry.
The corresponding Zone Lamps (1 to 4) will indicate the Area/s selected.
Press the Area number
for each Area that is to be Assigned or Un-assigned to this
User.
OPTIONS: 0 All Areas De-selected.
1 General Area (Single Area Mode) or Area 1 (Multi-Area Mode) selected.
2 Area 2 selected
3 Area 3 selected
4 Area 4 selected
When the required Areas have been Selected and/or De-selected, press
.
e.g.
If Area 1 and Area 3 are to be assigned to the User;
(And no Areas are currently assigned)
Press 1, 3, <ENTER>.
3 beeps will sound to confirm the new Area assignment data has been programmed.
6.2
USER PROGRAMMING
