Installation and programming manual
Programming from panel
53
9.3
Setting the Timers
From panel: <key>, Programming,
Progr. Timer
, select a timer,
Ok
This option will allow you define the timer intervals (e.g.: from 13.00 to 14.00), dates (e.g.: 25-12-2006)
or special days (e.g.: Sundays and days of closure). The timer can be included in an equation and can
contribute to the activation of an output. Timer activation may trigger associated actions (e.g. bypass a
zone, toggle to Night Mode).
Navigate through the programming field and set the new values.
9.3.1 Timer parameters
OUTPUT DISABLE-
MENTS
In this mode, the output will activate when any of the control panel components is bypassed (if
"Panel" option is selected), or when one or more zones (all the zones set as “YES”) are
bypassed.
Silenceable
As above.
Inverted
As above.
Duration
-- min -- sec
As above.
At least 1 / 2 /
All
The output will activate if at least one/two/all of the selected zones are
disabled.
OUTPUT EXTIN-
GUISH
In this mode the output activates in response to the signals relative to the extinguishant board
selected in the successive lines (“Disable manual”; “Disable automatic”; “Pre-extinguish”;
“Extinguish”; “Confirm extinguish”; “Pressure Switch”).
Silenceable
As above.
Inverted
As above.
Duration
-- min -- sec
As above.
OUTPUT SIGNALS
In this mode, the output will activate in response to the selected conditions (“Reset”, “Day”,
“Night”).
Silenceable
As above.
Inverted
As above.
Duration
-- min -- sec
As above.
OUTPUT TIMERS
In this mode, the output will activate in response to the activation of the specified timers (i.e.
all timers set as “YES”).
Silenceable
As above.
Inverted
As above.
Duration
-- min -- sec
As above.
OUTPUT EQUA-
TIONS
In this mode the output will activate when at least one of the equations specified on the
successive lines is satisfied (all the equations set as “YES”).
Silenceable
As above.
Inverted
As above.
Duration
-- min -- sec
As above.
Timer n
Timer number (maximum 8), preset.
Enabled
If you select "Yes", the selected timer will be enabled.
Start/End time 1
Hour and minutes of the Start and End of the interval 1.
