Installation and programming manual
User interface
25
5.2.2 LED
LED
If On solid:
ON blinking:
[H]
SILENCED
As per
paragraph 5.1
[I]
RESET DISABLED
As per
paragraph 5.1
[J]
INVESTIGATE
Indicates that investigation time has been
requested.
[K]
ALARM
As per
paragraph 5.1
[L]
PRE-ALARM
As per
paragraph 5.1
[M]
FAULT
As per
paragraph 5.1
[N]
CPU FAULT
Indicates that the repeater CPU is not operating
properly. If this occurs, the repeater must be
repaired immediately.
[O]
DISABLED
As per
paragraph 5.1
[P]
TEST
As per
paragraph 5.1
[Q]
NIGHT MODE
As per
paragraph 5.1
[R]
BATTERY
Indicates that the panel batteries are low or
inefficient.
Indicates restoral of the low/
inefficient battery event.
[S]
EARTH
Indicates voltage dispersion to earth.
Indicates restoral of the voltage
dispersion to earth event.
[T]
FUSE
Indicates protection fuse intervention due to
short-circuit on the AUX or AUX-R output.
Indicates restoral of the short-circuit
on AUX or AUX_R output event.
[U]
MAINS
Indicates Mains failure.
Indicates restoral of the Mains failure
event.
[V]
BELLS - ACTIVE
Indicates that the ALARM NAC output is active.
[W]
BELLS - FAULT
Indicates that a fault has been detected on the
ALARM NAC output.
Indicates restoral of the ALARM
output fault.
[X]
BELLS - DISABLED
Indicates that the ALARM NAC output has been
disabled.
[Y]
DIALLER - ACTIVE
Indicates that the DIALER output is active.
[Z]
DIALLER - FAULT
Indicates a DIALER output fault.
Indicates restoral of the Dialler
output fault.
[Z1] DIALLER -
DISABLED
Indicates that the DIALER output has been
disabled.
