LP630 Service Manual
43
Assembly Notes
♦
When you install the ballast, make sure the registration pins in the bottom case fit into the holes
adjacent to the front and rear screws.
♦
Make sure you replace the cable retainers on the front screw and the machine screw on the top of the
power supply.
♦
Route the lamp cable under the cable retainer on the front screw.
Summary of Contents for LP630
