LP630 Service Manual
11
Remove and Replace the Leveling Foot and Rubber Feet
The
leveling foot
(340-0931-xx) is located on rear corner on the projection lens side. It allows the user to
adjust the horizontal tilt of the projector.
One
rubber foot
(328-0138-xx) fastens to the corner opposite the leveling foot. Another identical rubber
foot fastens to the end of the elevator shaft.
Replace the leveling foot
1
Place the projector upside down on the work surface.
Rotate the foot counter clockwise until the foot and its attached shaft detach from the projector.
Note that a section of the shaft is not threaded.
When you replace the foot, turn the shaft clockwise until it reaches the non-threaded area. Then
start the threads on the lower portion of the shaft. Turn the foot until it is even with the bottom of
the projector.
Summary of Contents for LP630
