LYNX Manual RA02
1.4.4
Camera Power Connector
The power and all external input/output signals are supplied to the camera
via the camera power connector shown in Figure 1.6. The corresponding pin
mapping is shown in Table 1.4. The connector is a HIROSE type miniature
locking receptacle #HR10A-10R-10PB.
Figure 1.6 - Camera Power Connector (viewed from rear)
Pin
Signal
Type
Description
1
Trigger In -
TTL - Input
External Trigger Input
2
Trigger In +
TTL - Input
External Trigger Input
3
GND
Power - Input
Power Ground Return
4
GND
Power - Input
Power Ground Return
5
+ 12 V
Power - Input
+ 12 V Power Supply
6
+ 12 V
Power - Input
+ 12 V Power Supply
7
Strobe Out -
TTL - Output
Strobe Light Sync Pulse
8
Strobe Out +
TTL - Output
Strobe Light Sync Pulse
9
Auto Iris +
Input
Auto Iris Feedback Input
10
Auto Iris -
Output
Auto Iris Control Output
Table 1.4 - Camera Power Connector Pin Mapping
The camera is shipped with a power cable which terminates in a HIROSE
plug #HR10A-10P-10S, and has two small BNC pig-tail cables for the
external trigger input (black) and strobe output (white). The corresponding
BNC connector pin mapping is shown below.
Pin
Signal
Cable color
Description
Shield
Trigger In -
External Trigger Input
Signal
Trigger In +
BNC Black
External Trigger Input
Shield
Strobe Out -
Strobe Light Sync Pulse
Signal
Strobe Out +
BNC White
Strobe Light Sync Pulse
Table 1.5 - BNC Connectors Pin Mapping
www.imperx.com
25
of
154
5/6/2005
