Imagine Videotek LLM-1770, Installation And Operation Manual

Page: 55 / 122

LLM-1770
Installation and Operation Manual
49
Menu Selection Descriptions

Front Panel : This selection is used to raise or lower the brightness levels of the front
panel function buttons.

High Tally : This selection is used to set the brightness of the High Tally state. The
range of button contrast is 35% to 100%. The default selection is 80%.

Low Tally : This selection allows for setting the brightness of the buttons in a low
tally state. The range of brightness is 0% to 10%. The default selection is 5%.

GPIO : This selection is used to enable general purpose inputs/outputs.

Input 1 : This selection enables the use of GPIO input 1. Selections include No
action, a user-set GPIO alarm, or Run/Pause.

Input 2 : This selection enables the use of GPIO input 2. Selections include No
action, a user-set GPIO alarm, or Clear the collected loudness information for both
program 1 and program 2.

Input 3 : This selection enables the use of GPIO input 3. Selections include No
action, a user-set GPIO alarm, or Select Bars Display.

Input 4 : This selection enables the use of GPIO input 4. Selections include No
action, a user-set GPIO alarm, or Select Loudness Display.

Output Polarity : This selection is used to indicate that an alarm has occurred. It
can be set to either Normally Open or Normally Closed.

Output Setup : This selection is used control the contact closure logic.

If Follow Alarms is selected, the output will close on the leading edge of any
enabled alarm and clear two seconds after all alarms have cleared .
Output Polarity Normally Open*
Normally Closed
Output Setup Follow Alarms*
Latched
IP DHCP Control Off*
On
IP Address
Subnet Mask
Gateway Addresses
Front Panel Lock Off
On*
System Time YYYY/MM/DD HH:MM
Logs Naming Convention Use Serial Number
Use Custom String*
Custom String
Alarm Log Overwrite Oldest*
Stop Collection on Disk
Full
Table 4-9 Unit Configuration Setup Menu (Continued)
Selection Option Selection Option Selection Option